Unit Conversions of Logger Data in Collect

Collect can convert between the following units when capturing logger data in Collect Mobile. For example, if the temperature unit selected when setting up the form in Collect Enterprise (see Setup Form) is °F, but the data logger only provides the temperature in °C, Collect Mobile will convert the temperature from °C to °F.

Unit Group	Converts Between
Concentration	•ppb (parts per billion) •ppm (parts per million) •ppt (parts per thousand)
Conductivity	•mS/cm •mS/m •S/m •uS/cm
Density/Mass Concentration	•g/cm3 •g/L •kg/L •kg/m3 •mg/L •ug/L
Distance/Length	•cm •ft •in •km •m •mm
Flow	•acre-ft/day (acre feet per day) •ft3/day •ft3/hr •ft3/min •ft3/s •L/s •m3/day •m3/hr •m3/min •m3/s
Pressure	•Bar •cmH2O (4 °C) (centimeters of water at 4 °C) •inH2O (4 °C) •inHg (0 °C) (inches of mercury at 0 °C) •kPa •mBar •mmHg (0 °C) (but not mmHg without a temperature) •Pa •PSI (but not PSIA, G, or R) •Torr
Resistivity	•kohm-cm (kilo ohm-centimeters) •Mohm-cm •ohm-cm
Temperature	•°C •°F •K
Voltage	•mV •uV •V

Please contact EarthSoft Support if additional unit conversions are needed.

Warning: Selecting 'Any' unit when setting up the form (in Collect Enterprise) will capture any unit that the data logger provides for the specified parameter (e.g., Temperature) and can be used if the unit is not known or not listed in Collect Enterprise. However, if the data logger provides more than one unit (e.g., °C and °F), then 'Any' could capture either °C or °F.